An auto-watering reservoir and drip lines being installed among potted plants
← Back to home

Watering that keeps happening, even on busy weeks

An installation and calibration visit that sets your reservoir, tubing, and drip heads to your actual pots.

The promise

One visit, a documented schedule that fits

We come to you, install the reservoir, tubing, and drip heads for up to twenty pots, and calibrate each flow rate against how your substrate actually drains — not a generic factory setting. You are left with a printed schedule card and, two weeks later, a follow-up check to see if intervals need a small adjustment.

The problem

Watering is the first habit to slip

Even careful growers miss a watering day when work gets busy or travel comes up. A pre-set timer helps, but only if it is actually calibrated to your pots — otherwise it either drowns fast-draining orchid bark or leaves thirsty tropicals dry. Getting that balance right by trial and error can take a full season of guesswork.

The solution

Calibration measured on site, not assumed

During the visit, we measure substrate drainage pot by pot and set flow rates accordingly — orchid bark, general potting mix, and succulent blends all behave differently under the same drip head. The result is a system tuned to your actual collection, covering one room or balcony arrangement in a single appointment.

The experience

What the visit looks like

About 90 minutes

One appointment covers a full room or balcony arrangement.

Placement first

Reservoir position and tubing routes are planned around your space, not squeezed in.

Explained as we go

We walk you through what each drip head is doing and why.

A check-in that follows up

Two weeks later, a message asks how the schedule is settling in.

The investment

What's included

¥4,200

Installation visit, up to twenty pots, ~90 minutes

  • · Reservoir, tubing, and drip-head installation
  • · Per-pot flow rate calibration on site
  • · Printed watering schedule card
  • · Two-week follow-up message
The proof

A simple schematic, explained plainly

RESERVOIR

Filled and positioned away from direct heat or afternoon sun.

TUBING RUN

Routed along shelf edges, secured so it stays out of the way.

DRIP HEADS

Placed per pot and flow-tested before the visit ends.

Timelines vary by household — most people notice the biggest difference within the first two to three weeks, once the two-week check-in has fine-tuned the schedule.

The guarantee

If the schedule needs adjusting, we adjust it

The two-week follow-up exists precisely because a first calibration is rarely perfect on day one. If intervals still feel off after that check-in, reach out and we will help you fine-tune it further — this is part of the service, not an extra charge.

Next steps

How to get started

01

Tell us roughly how many pots and where you're based in the Tokyo area.

02

We schedule a visit at a time that works for you.

03

We install, calibrate, and leave you with a schedule card.

Ready to stop worrying about watering?

Tell us about your collection and we'll arrange a visit.

Book an installation